 |
 |
|
 |  |  |  |  | Medical Electrodes |
Medical Electrodes (Electrode Applicators) Used with Inergetix-CoRe System
Hair Electrode & Veterinary Electrode
Applies resonant frequencies on hair and fur, suitable for animals as well as people
|
Cosmetic and Facial Electrode
Applies resonant frequencies on skin to stimulate circulation, improve skin tone, minimize the appearance of wrinkles |
Acupuncture Electrode
Applies resonant frequencies to acupuncture points and meridians |
Roller Electrode
Applies resonant frequencies while massaging along muscles and body parts |
Light-Weight Wrist/Ankle Electrodes
Enable the client to be physically connected to the system during the analysis. Plastic, in the style of SCIO/LIFE (but not recommended if you can get our superior gold hand electrodes) |
Note Regarding the New Electrode Applicators:The four new electrodes allow electric frequency balancing with more focus on a certain area of the body. Together with these electrodes we offer a set of two cables, an extension-cord and a conversion-cord. Both are plugged in between the audio port of the Inergetix CoRe Interface unit and the plug of the electrode but their function is different as follows:
Extension-Cord
 Works simply as an extension to the cord that comes with the actual electrode. As each electrode has a plus and a minus area it is not required to use an additional hand-electrode or the foot-electrode. Also because the plus and the minus area are so close to each other, usually the current is not felt as in the case of using the hand and foot electrode where the electricity goes through large parts of the body. If you are seriously in doubt if an electrode is working you can set the Amplitude at the lowest value which is 1 Volt and put the electrode on your moistened wrist and you certainly will feel a tingling if everything is working. Gradually increase the voltage until it is felt.
Conversion-Cord
 Is converting all electrodes into single polarity applicators. Therefore in order to work and an electric circuit to be formed, one has to use an additional electrode, either one hand or one foot-electrode connected to the REFERENCE port. Then the electricity runs from this reference-electrode to the electrode-applicator.
Particularly when using the new Acupuncture probe the electricity is very pointed and is therefore subjectively felt much stronger than previously. We recommend therefore because the sensitivity to electricity varies individually very much that you start very low with 1-3 Volt on the amplitude setting in order not to frighten your client.
To easily remember, note that the gold end of the conversion-cord connects to the gold electrodes (hand and foot electrode).
Using Together with the Plasma-GeneratorAs the body of different people absorbs electricity very differently in some rare cases it may happen that electric frequency treatment run in parallel absorbs so much energy that the Plasma-generator does not work. In this situation one has to disconnect the electrodes while doing light therapy with the plasma-generator. Also it is important that while using the Plasma generator one forms a habit to disconnect electrodes if they are not used to avoid the possibility of a short-current in case they would touch each other.
*To avoid misinterpretation of words such as energy-medicine, informational-medicine, treat, cure, diagnose, illness, disease, remedy and spiritual healing please study our Vision and Mission page carefully. CoRe System users in the USA are required to read and accept these interpretations.
© 2007-2008, Inergetix, Inc. All Rights Reserved
|
|
 |
Support
